Skived PTFE Tape 2 Mil, Silicone Adhesive - High Density for Electrical Insulation

Skived PTFE Film Silicone Adhesive Tape

Product Description

WOD SPTFE2HD Skived Teflon Tape is a 2 mil high density tensilized pure skived Teflon™ (PTFE film) tape with a high temperature silicone adhesive. It comes self-wound without a liner. Used in electrical applications such as harness / coil wraps & separators, transformers and slot liners where good insulation and heat resistance are required. Also used in mechanical applications such as heat sealing bars & jaws, labeling machine pressure pads, chute liners, anti-friction devices, bearings, forming dies, aircraft mold release & guide rails where high temperature, maximum slip and lubricity are required.

WOD SPTFE2HD provides higher tensile strength, lower elongation and higher dielectric strength than regular skived film. It is primarily used for electrical applications listed above & for roll protection in flat die extrusion. Made in the U.S.

Product Applications

• Used in mechanical applications such as heat sealing bars & jaws, labeling machine pressure pads, chute liners, anti-friction devices, bearings, forming dies, aircraft mold release & guide rails where high temperature, maximum slip and lubricity are required.
• Used in electrical applications such as harness/coil wraps & separators, transformers & slot liners where good insulation & heat resistance are required.
• Anti-stick tape for wrapping rollers, plates, belts or other parts where buildup can occur.
• Used primarily in electrical appliances such as coil wraps and separators, transformer, slot liners and harness wrapping where good insulation and heat resistance are needed
• Used in mechanical applications requiring high temperature resistance and a non-stick surface such as roll protection in flat die extrusion.

Technical Properties

• Adhesive: Silicone How are adhesives different?
• Carrier/Backing: polytetrafluoroethylene (PTFE) film / pure skived Teflon
• Thickness: 3.5 mils (carrier, adhesive) What is mil thickness?
• Adhesion: 25 ounces per inch (to stainless steel test panel)
• Tensile Strength: 30 pounds per inch (longitudinal)
• Dielectric Strength: 8,000 volts
• Elongation: 100%
• Specification Met: MIL-I-23594C Type 1 (revised spec. CID A-A-59474)
• Service/Operating Temperature: -100°F to 500°F
• Core: 3" Diameter

Additional Information

Alternative to: 3M 5480; Permacel P422; DeWal 204-2HD; Saint Gobain 2255-2; Taconic 6445-02; Chemfab 380-02; Lanmar 585-2; Bondtec 932F

Note: Specifications are those given by manufacturers and are not tested for accuracy.